VALERA VOLUMISSIMA - Manual (Page 3)

5
• Only connect this unit to alternating current and check that the mains supply voltage corresponds to
that indicated on the unit.
•Never immerse this unit in water or other liquids.
•Do not put this unit down where it could fall into water or other liquids.
•Do not try to pull any electrical appliance out when it has fallen into water - disconnect the plug
from the power socket immediately.
•Make sure the unit is perfectly dry before using it.
•Do not put the appliance on heat sensitive surfaces during use.
•After use always switch the unit off and remove the plug from the power supply socket. Do not pull
on the wire to remove the plug from the power supply socket. Do not pull the plug out of the power
supply socket when your hands are wet.
•Always allow the unit to cool before putting it away and never wrap the cord around the unit.
•Check that the cord has not been damaged from time to time.
•Prevent the cord from coming into contact with the metal parts while these are still hot.
•Use the unit on dry hair.
•Do not use this unit on wigs that have synthetic hair.
•The elements used to pack the unit (plastic bags, cardboard box, etc.) must be kept out of reach of
children as they are a potential danger to them.
•This unit must only be used for the purposes for which it is expressly intended. Any other use is to
be considered improper and therefore dangerous. The manufacturer accepts no responsibility for
damage caused by improper or erroneous use.
•Do not use hair spray while the unit is running.
•Keep the plates clean and free of dust, hair spray, styling gel, etc.
•To avoid dangerous overheating, it is advisable to unwind the entire length of the cord.
OPERATING INSTRUCTIONS
Parts
1. Appliance
2. Plates
3. ON/OFF switch
4. Temperature switch
Switching the appliance on and off
To switch the appliance on, simply plug it in to an electrical socket and move the switch (fig. 1, ref. 3)
to “I”. To switch it off, move the switch (fig. 1, ref. 3) to “0” and remove the plug from the socket.
Important: never leave the appliance unattended when on.
Temperature settings
To set the temperature for use turn the switch (fig. 1, ref. 4) to the desired value.
You can select different temperatures depending on the type of hair to be treated:
up to 150°C for fine, straight hair
up to 210°C for fine, wavy hair
up to 230°C for thick, curly hair
Guide to red and green indicator light (fig. 1, ref. 5 and 6) operation:
• red indicator light illuminated: appliance in operation
• green indicator lights flashing: ready for use, set temperature reached
• green indicator lights illuminated (fixed light): plate heating in progress
• green indicator lights off: plate cooling in progress.
OPERATING TIPS:
This appliance was designed to give your hairstyle extra volume by lifting hair naturally, at the root.
This increase in volume is achieved through the creation of a wave at the very root of the hair (right
next to the scalp).
Please take the following advice into account when using the appliance:
• Hair that has just been washed and dried can be styled better.
• The first few times you use this unit it is advisable to practice on small areas of your hair.
• Wait for the appliance to reach the set temperature.
• Brush hair and separate it into 2 cm sections.
• Release the plate locking device (fig. 1, ref. 7).
• If you decide to begin working at the top of the head (fig. 1), the hair next to the parting should not
be styled using the appliance. This will ensure that the uppermost layer of hair remains smooth,
hiding the slightly crimped effect of the layers underneath (fig. 3).
• Place the first section of hair between the plates (fig. 1, ref. 2), making sure the appliance is as
close to the hair root as possible (fig. 2).
• Keep the plates pressed together for approximately 2/3 seconds.
5. Red indicator light
6. Green indicator light
7. Locking device
00060512 int sett2013 13/09/2013 10.14 Pagina 5