Acnodes FES 2213 - Manual (Page 14)

3. DDRIII SODIM M Socket [refer to CN 3]
One 204-pin/ H9.2 mm DDRIUII DIMM socket supports DDR3 800 MHz (N26 00)/ 106 6 MHz (N2800 )
up to 4GB.
4. GPIO (General Purpose Input Output) [refer to CN4]
The board supports 8-bit GPIO ( 5V tolerance) through GPIO pin heade r. The 8 digital inputs and
outputs can be programmed to read or control devices, wi th each input or output defined.
5. VGA/ LVDS Interface Connections [refer to CN5 a nd CN 18]
The MIO-2261’s VGA interface can drive conventional CRT displays and is capable of driving a wide
range of flat panel displays, including passive LCD and active LCD displays. The board has t wo
connectors to support these displays: one for standard CRT VGA m oni tors and one for LVDS type
LCD panels.
CRT display connector
[refer to CN 5]
The CRT display 1 5pins connector is a rear I/O connector on coastline used for conventional CRT
displays. Resolution: up to 1 920 x 12 00 (WUXGA).
LVDS LCD panel connector
[refer to CN 18]
The board supports single channel 18/24 -bit LVDS LCD pane l displ ays via 14*1pin wafer box.
Resoluti on: up to 1366 x 768 ( WXGA).
6. mSATA Connector [refe r to CN6]
MIO-226 0 provides a mini-P CIe socket which integrates USB and SATAII signals, supports either
mSATA or USB interface modules.
7. SATA Connector [refer to CN 7]
MIO-226 1 features one high perform ance Se rial ATA interfaces. Data transfer rates up to 300 MB/s
enabling very fast data and fi le transfer, and independent DMA operation on two ports.
8. M ini PCIe Connector [refer to CN8 ]
MIIO-2261 supports a half size mini PCI2 slot. PCI Express Mini Card (also known as Mini PCI
Express, Mini PCI2, and M ini PCI-E) is a repl acem ent for the Mini P CI form factor based on P CI
Express. It is developed by the PCI-SIG. The host device supports both PCI Express and USB 2.0
connectivity.
9. USB Connectors [refer to CN9 and CN 10]
The board provides four USB (Universal Se rial Bus) ports, two are rear I/O on coastline ( CN9); and
the other two are internal USB ports ( CN10) . These gives complete Plug and Pl ay, and hot attach/
detach for up to 127 external devices. The USB interfaces comply with USB specification Rev 2.0
which support 480 Mbps transfer rate and are fuse protected.