Acnodes FES 2213 - Manual (Page 15)

10. COM Port Connectors [refe r to CN11]
MIO-226 1 provides 2 x RS-232 serial ports in 10* 2pi n pin header. It provides connections for serial
devices or a com munication network. The pin assignments for the COM port connector can be
found in Jumper Setting.
11. SMBus Connector [refer to CN1 2]
MIO-226 1 provides SM Bus connector for customer connection to SM Bus protocol em bedded
device. It can be configured to I²C by customer’s request.
12. Front Panel Connector [refer to CN13]
MIO-226 1 integrates below functi ons as front panel 6pin connector.
Power Button
Supports powe r on/off button in ATX mode.
Reset
If you install a reset switch, it should be an open si ngle pole switch. M omentarily pressing the
switch will acti vate a reset.
Power LED
Power LED indi cator would light when power is on.
HDD LED
HDD LED indicator for hard disk access is an active low signal.
13. Gigabit Ethernet Connector [refer to CN14]
MIO-226 1 uses Intel®82583 C Ethernet chip (10/ 100/ 1000 Mbps) l ined to dedicat ed PCI2 x 1 lane
via RJ-45 connector.
14. High De finition Audio Interface [refer to CN 15]
MIO-226 1 provides one 5x 2 pin box header for audio device. It can support high definition audio
stereo by customized audio module that has codec onboard.
15. Front Panel Conne ctor [refer to CN13]
MIO-226 1 supports MIO2 connector to extend flexible I/Os.
Interface
2 x USB 2.0, 2 x P CIe x 1, LPC, HD Audio line-out, SMBus, DP (or HDMI, supported by request), 5 Vsb/
12 Vsb power.
Total peripheral power supply output
5V @ 3A for CPU board and MI/O Extension module totally, 1 2V @ 2A for M I/O Extension module.
16. Inverter Power/ Internal SATA Power Connector [refer to CN17]
The LCD inve rter is connected to CN17 via a 5-pin connector to provide +5V/ +12V power to the LCD
display, and 5 V powe r can be provided for 2.5” SATA HDD via CN17.
SATA powe r’s current is only sufficient for 2.5” HDD, and LVDS inverter ’s cur rent is 5V @ less than
1A, 12V @500mA.