Acnodes FES 2215 - Manual (Page 36)

Chapter 4: Installation Guide
4-1. Memory Modules (SO-DIMM)
Pipal 2215 provides two 240-pin DDR3 SO-DIMM slots.
- It is NOT allowed to install a DDR or DDR2 memory module into a DDR 3 slot; otherwise, the
motherboard and SO-DIMM may be damaged.
- Please install the memory module from DDR3_A2 slot as the 1 st priority.
4-1.1 Installing a SO-DIMM
Please make sure to disconnect the power supply before adding or removing SO-DIMMs or the
system components.
STEP 1: Unlock a SO-DIMM slot by pressing the retaining clips outward.
STEP 2: Align a SO-DIMM on the slot such that the notch on the SO-DIMM matches the break on the slot.
The SO-DIMM only fits in one correct orientation. It will cause permanent damage to the
motherboard and the SO-DIMM if you force the SO-DIMM into the slot in the incorrect orientation.
STEP 3: Firmly insert the SO-DIMM into the slot until the retaining clips at both ends fully snap back in
place
and the SO-DIMM is properly seated.