1101 module interface installation, Nstructions, Figure 10: module interface to elt connection – ACR&Artex ME406 ACE 455-0023 User Manual

Page 20

Advertising
background image

Artex Products / ACR Electronics, Inc.

570-0023 Rev. G

Page 20 of 33

8.

453-1101 MODULE INTERFACE INSTALLATION

8.1 Instructions

8.1.1 Place the two sealing strips 850-0814 provided in the 455-7420 install kit into the ELT

15-pin D-sub connector.

8.1.2 Insert the module interface 453-1101 into the ELT D-sub and secure it in place using the

two thumbscrews. The torque on the thumbscrews is 4 to 5 Lb-in.

Figure 10: Module Interface to ELT Connection

(Red Wire - Horn Power, Black Wire - A/C Ground, Blue Wire – Cap & Stow)

8.1.3 Fasten the three wires along the harness within one inch of the module interface using

cable ties.
NOTE: The length of the wires between the end of the module and the first cable tie

should have enough slack to provide strain relief.

8.1.4 Fasten the harness to the aircraft. Ensure that the harness has enough slack to prevent

tensile load on the modular jack connector of the module interface.

8.1.5 Plug the modular jack connector of the harness to the remote switch 453-0023 if it is

already installed.

8.1.6 Refer to the Transmitter Test section of the ME406 series ELT manuals to check the

operation of the complete connection to the ELT.

8.1.7 Enter the date, installer’s initials and whether the ELT passed or failed into the aircraft’s

logbook.

Advertising