ACR&Artex Float-Free 406 Memory Capsule - Manual (Page 12)

Y1-03-0199 Rev. E 9
2. Cutter Mechanism Installation
A) Insert the flex cable cutter mechanism into place.
B) Position the cutter with the release arm extending across the ejector spring and the slot for the flex cable
positioned at the top.
C) Simply push the cutter into the slot until the teeth connect and lock the mechanism into place. Try to pull it back out
to make sure the device is locked in securely.
Use extreme caution when installing the Float Free Memory Capsule cutter mechanism. By releasing the pin located
on the top of the mechanism, the cutter blade will be activated. Once this device has been activated it must be
replaced by a new cutter mechanism (P/N 2520).
To remove the flex cable cutter mechanism from the bracket first remove the flex cable from the cutter (if already
installed). Next, simultaneously push the two plastic bracket teeth in opposite directions. W hile the two teeth are
pushed back pull the cutting mechanism out of the bracket.
Release Arm
Flex Cable Slot Release Pin
Release Arm
Flex Cable Slot
Cutter Mechanism Installation (Figure 6)