Acroprint Data Collection Terminal (ADCT) - Manual (Page 11)

11
(For RS485 terminals only)
Select option 1 for RS485 <press ENTER>
Select the baud rate 0 for 1200, 1 for 2400, 2 for 4800, 3 for 9600
and 4 for 19,200 baud. <press ENTER>
(For Ethernet terminals with ATR9800 only)
Select option 2 for Ethernet <press ENTER>
Select the baud rate option 3 for 9600 baud <press ENTER>
(Leave this as the default for Ethernet.)
Select the TCPIP address <press ENTER>
(Your network administrator will have this information.)
Select the GATEWAY address <press ENTER>
(Your network administrator will have this information.)
Select the PORT VALUE <press ENTER>
(Default number 10001. Select the same value in the ATR9800
software.)
Select the NETMASK VALUE <press ENTER>
(Your network administrator will obtain this information. The
Network SubNetMask TCPIP number contains 4 elements of
numbers separated by “.”. To determine the NETMASK VALUE
obtain your Network SubnetMask IP number from the Network
administrator, i.e. XXX.255.255.000. Convert the last three elements
(your numbers will be different) to binary and count the total number
of zero’s in each binary element and enter this number. 255 =
11111111 in binary, 000 = 00000000. Each 255 contains NO zeros
therefore the Netmask value bits number is set to 08 for the example
XXX.255.255.000.) The Ethernet terminal Netmask values can range
from 01 to 24.
Select the TERMINAL TRANSACTION PRINTER TYPE
<press ENTER>
(default is parallel port)
Ports and connections