Fagor FFK6845 - Manual (Page 20)

13
1
Instruction manual
Very important: Read this manual carefully before using your refrigerator.
This manual is designed with texts corresponding to drawings.
Installation
Identify the model of your refrigerator (“a”, “b”,
“c”, “d”, “e”, “f”) by comparing the control panel
with the illustrations.
1.1 Unpacking. Remove all protective elements.
1.2 Placement. Place the refrigerator away from
heat sources and protect it from direct sunlight in
order to conserve energy.
Do not install the refrigerator in the open air or
where it is exposed to rain.
Air should be able to circulate behind the
refrigerator. Leave 25 mm between the rear of
the refrigerator and the wall. Do not enclose the
space between the refrigerator and the fl oor or
ceiling with any object.
Level the refrigerator to prevent vibration and
noise. Remember that if the refrigerator is
situated next to a wall or cupboard, it could
make some noise.
In addition, make sure that the trays are correctly
placed and position the containers with a space
between them to prevent vibration.
1.3 Connecting to power. Let the refrigerator sit
in a upright position for at least 2 hours before
connecting it. Check the information on the
specifi cation plate (220-240V with ground wire)
(1.3.1, 1.3.2).
Do not use adapters or extension leads.
Prevent the cord from coming in contact with
the motor or getting trapped beneath it.
1.4 Changing the side that the door opens from.
Disconnect the refrigerator from the power outlet
and empty the inside of the door.
Remove the screws (1.4.1) and take out the top
0
Identifi cation
e n g l i s h
hinge and the rotation bushing with the aid of a
screwdriver (1.4.2).
Disconnect by pressing the connector tab.
(1.4.3). Remove the refrigerator door (1.4.4).
Remove the controls with a screwdriver, prying it
away using the grooves placed for that purpose
(1.4.5).
Make a notch for the cable on the opposite
side, as marked on the casing (1.4.6). Remount
the control panel passing the cable through the
notch you made (1.4.7)
Remove the screw cover from the centre hinge,
loosen the screws and remove the hinge (1.4.8).
Move the freezer door up (1.4.9).
Loosen the screws of the lower hinge and
remove it. Change the position of the hinge axis
and place it on the opposite side.
Place the lower freezer handle on the refrigerator
door and the lower refrigerator handle on the
freezer door, rotated 180º. Place the vertical
handles on the opposite side rotating them 180º
(1.4.11).
Rotate the self-closures and place the one from
the refrigerator on the freezer and vice versa
(1.4.12).
Position the freezer door (1.4.13) and attach the
central hinge (1.4.14). Position the refrigerator
door (1.4.15).
Place the closing cap in the space for the top
hinge on the opposite side (1.4.16). Press the
connector to plug it into the door (1.4.17).
Fit the top hinge and the rotation bushing,
threading the excess cable into the control panel
(1.4.18), and screw in the screws (1.4.19).
2.1 Switching on the refrigerator. Press
(2.1.1), (2.1.3) or the plus or keys until
you see a number in the display (2.1.2). The
Mini LCD models lock automatically (2.1.3). To
unlock, press any key for 3 seconds.
2
Operation