Activeforever Snow Joe Plus 322P Electric Snow Thrower - Manual (Page 5)

5
Operation
NOTE: It is best to remove snow before it becomes packed
down.
1. Extension cord: Note that the snow thrower has a polarized
plug (J), with one prong slightly longer and wider than the
other. The extension cord plug and the slotted end should be
likewise polarized, so that the original plug fits snugly into the
extension cord slots.
To prevent the snow thrower cord and extension cord from
disconnecting during use, tie the extension cord into a loose
knot around the lower bar (K) of the handle as shown in next
step (Figure 7, Item O).
2. Plug the extension cord into a wall outlet. Insert the key
(L) into the slot in front of the hand-grip (M) (Figure 7).
Powering On and Off
3. Insert the key (L). Squeeze the On/Off switch (N), as shown in
Figure 7. Release the switch by releasing grip pressure.
4. When finished with work, remove the key and disconnect
the extension cord.
WARNING
m m
Electric shock may cause SEVERE INJURY or
DEATH. Heed these warnings:
• Do not allow any part of snow thrower to make contact
with water while powered on. If the appliance becomes
wet while turned off, wipe dry before starting.
• Use only a UL-rated extension cord for outdoor, all-
weather use. Do not use an extention cord over
150 feet (46 meters).
• Don!t touch the appliance or its plug with wet hands.
Don!t stand in water; wearing rubber boots offers
some protection.
Figure 6
Figure 7
L
O
M
K
K. Lower bar
L. Key
M. Hand-grip (Top bar)
N. On/Off switch (under hand-grip)
O. Cord tied to handle
N
Cord length is: 100 ft. (30 m) 150 ft. (46m)
Wire gauge is: 16 14
EXTENSION CORD CHART
J
J. Polarized plug