Acura 2012 TSX Sport Wagon - Manual (Page 282)

uu Temporarily Repairing a Flat Tire u
280
Han
d
lin
g the U
n
expected
10. Unplug the power plug from the accessory
power socket.
11. Unscrew the sealant/air hose from the tire
valve stem. Reinstall the valve cap.
12. Apply the repair notification label to the
flat surface of the wheel.
u The wheel surface must be clean to
ensure the label adheres properly.
1. Apply the speed restriction label to the
location as shown.
2. Drive the vehicle for about 10 minutes.
u Do not exceed 50 mph (80 km/h).
3. Stop the vehicle in a safe location.
Sealant/Air Hose
Valve Stem
Repair Notification Label
■ Distributing the Sealant in the Tire 1 Distributing the Sealant in the Tire
Stop and recheck the air pressure after every 10
minutes of driving as necessary until you reach the
nearest service station where you should have the tire
permanently repaired or replaced.
Speed Restriction Label
2012 TSX5D-31TL7610.book 280 ページ ２０１１年７月１１日 月曜日 午前８時１０分