Acura 2013 RDX Navigation - Manual (Page 138)

137
 Audio System  System Theft Protection
Audio
System Theft Protection
The system is disabled when it is disconnected from the power source, such as when
the battery is disconnected or goes dead.
■ Reactivating the System
1.
 If you set the power mode to ACCESSORY, you will be requested to enter
the security code. See step 3.
2. Press and hold the VOL 9 (Volume/Power) button again for more than two
seconds.
 The system is reactivated when the system’s control unit recognizes that the
system is in your vehicle.
 If the control unit fails to recognize, “ENTER CODE” appears on the navigation
screen.
3. Enter the security code.
 If you do not enter the code correctly after 10 tries, leave the system for one
hour before trying again, or visit a dealer to have the system reset.
1 Audio System Theft Protection
Find the audio system’s security code and serial
number label in your Owner’s Manual kit.
Do not store the label in your vehicle. If you lose
the label, you must first retrieve the serial
number, and then obtain the code from a dealer.
U.S. Only
You can register the security code at My Acura
(owners.acura.com.), and find information on
how to retrieve the serial number and obtain the
code at radio-navicode.acura.com.
2 Entering the Security Code P. 230
RDX_KA-31TX4800.book Page 137 Monday, January 30, 2012 11:32 PM
QRG
2013 RDX Navigation
Set the power mode to ON and turn on the system.