Sequential shift mode operation – Acura 2013 RDX User Manual

Page 248

Advertising
background image

247

uu

When Driving

u

Shifting

Driving

Second gear lock mode

If you pull the

(

+

paddle shifter while stopped or driving at 6 mph (10 km/h) or less,

the gear position will be locked in 2nd gear. This makes it easier to pull away on
slippery surfaces such as snow covered roads.

To cancel the 2nd gear lock mode, pull the

paddle shifter, or move the shift lever

from

(

S

to

(

D

.

Sequential Shift Mode Operation

-

1

Sequential Shift Mode Operation

Each paddle shift operation makes a single gear
change.

To change gears continuously, release the paddle
shifter before pulling it again for the next gear.

Recommended Shift Points
Use this table as a guideline for efficient fuel
economy and effective emission control.

The gear position indicator blinks when you cannot
shift up or down. It indicates that your vehicle speed
is not in its allowable gear shifting range.
Slightly accelerate to shift up and decelerate to shift
down while the indicator is blinking.

Shift Up

Normal Acceleration

1st to 2nd

15 mph (24 km/h)

2nd to 3rd

25 mph (40 km/h)

3rd to 4th

40 mph (64 km/h)

4th to 5th

45 mph (72 km/h)

5th to 6th

50 mph (80 km/h)

Paddle Shifter
(Shift down)

Downshifting when
pulling the

paddle

shifter.
(Changes to a lower
gear.)

-

Upshifting when pulling
the

(

+ paddle shifter.

(Changes to a higher
gear.)

-

(

+ Paddle Shifter

(Shift up)

2013 RDX

QRG

Index

TOC

Advertising
This manual is related to the following products: