Setup, Count direction, Position recall – ACU-RITE 100S User Manual
Page 13
10
100S
Reference Manual
SETUP
•
Move to the “Count Direction” display in the Setup mode. (Press
SETUP
and then the
ENTER
key until “Ct dir” appears).
•
Press the appropriate axis key (
X
,
Y
or
Z
) until the
count direction
(1 or 2) appears.
•
After you complete setting your count direction, press
ENTER
to con-
tinue with setup or press
ENTER
then
SETUP
to return to the normal
DRO display.
To change the count direction:
Count Direction
Use the count direction setting to define the positive counting direction
for each scale. The direction will be displayed as a “1” or a “2” (the
numbers are not assigned to a particular direction). You only need to
change the count direction if the scale is counting in the negative
direction during a positive table move, or vice versa.
Refer to Conventions on pg. 37 for more guidelines.
Position Recall
•
Set this parameter to the ON position to store the last position
of each axis when power is turned off.