Binatone KS-7030 - Manual (Page 6)

6
OPERATION INSTRUCTIONS
Operation of the device
1. Place the cradle (1) in the operating position
having turned it by 90 degrees.
2. Press “On/Tare” button (3) to turn on the de-
vice. First the word “Helo” appears on the dis-
play (2) and afterwards “0” will be indicated.
3. To select measurement units press the “Unit” button (5) once or
twice until a desired mode is set. While pressing the button (5) the
symbols “g” (grams) and “oz” (ounces) will appear successively
in the right portion of the display showing the current active mea-
surement unit.
4. Put foodstuffs onto the cradle (1). Always put an object to be
weighed on the center of the cradle (or bowl). Bear in mind that its
weight should not exceed 2 kilograms.
Note: If the bowl is used place it securely onto the cradle
(1) before turning on the device.
5. Wait till the readings on the display (2) become stable and the
weight of your object is indicated.
6. After the weighing is complete lift the cradle (1) into the upper
position.
Setting off the tare weight
Turn on the scale. After zero reading is set, place an empty con-
tainer onto the cradle (1). Press the “On/Tare” button (3) to offset
the tare weight. When this function is active the indication Tare ap-
pears in the left portion of the display. Carry out further weighing food-
stuffs according the instructions.
Successive weighing
You can carry out successive weighing without removing the cradle
or foodstuff already on it, to do this press the “On/Tare” button (3)
once; before each additional weighing. This action will set the device
in zero position for each new measurement. The display (2) will indi-
cate only the weight of foodstuff being added last. When this function
is active the indication Tare appears in the left portion of the display.
When the weighed object is removed from the cradle (1) the display
will indicate a negative value.
Note: If the tare weight exceeds 20 g then maximum
foodstuff weight being measured will be decreased by
a value corresponding to the tare weight. If the tare
weight is less than 20 g the maximum weight being
measured does not change and equals to 2 kg.
Setting the time
1. To set the real time press the “Mode” button (4) till TM appears in
the right portion of the display. This means that the device entered