SEVERIN KB 2921 - Manual (Page 8)

that they do not play with the appliance.

No responsibility will be accepted if
damage results from improper use, or if
these instructions are not complied with.
 Th is appliance is intended for domestic or
similar applications, such as in
- shops, offi ces and other similar working
environments,
- agricultural areas,
- hotels, motels etc. and similar
establishments,
- bed and breakfast type environments.
- Th is appliance is not intended for
commercial use, nor for use in the
catering business or similar wholesale
environments.
 In order to comply with safety regulations
and to avoid hazards, repairs of electrical
appliances must be carried out by qualifi ed
personnel. If repairs are needed, please
send the appliance to one of our customer
service departments. Th
e address can be
found in the appendix to this manual.

If the unit is sold, handed over to a
third party or disposed of at a suitable
recycling facility, attention must be drawn
to the presence of the foaming agent
‘cyclopenthane’ in the insulation.
General information
Th
is cool-box uses thermo-electric
technology and is therefore able to provide
cooling as well as heating. Th
e appliance
cools down to as much as approx. 20° C
below ambient temperature.
Operation mode selector switch
Th e cooling function is switched on.
0 Th e appliance is switched off .
Th e appliance is in ‘keep-warm’ mode.
Voltage selector switch
Th
e voltage selector switch setting must
correspond to the power source currently
being used. Always ensure that the switch is
in the correct position before the cool-box is
connected to any power source.
AC power – for 230V mains operation,
the voltage selector must be set to AC
voltage.
DC power – for operation from a 12V
power source, the voltage selector must
be set to DC voltage.
Indicator lights
Th
e ‘cooling’ function is indicated by the
green light.
Th
e red indicator light shows that the ‘keep-
warm’ function is enabled.
Lid
Th
e lid can be locked by folding the carrying
handle over towards the hinged side of
the lid. To unlock, move the handle to the
opposite side.
Operation
– Place the lid on the cool-box, ensuring that
the hinges on the lid connect properly with
the receptacles on the cool-box itself.
– Use the voltage selector switch to set the
required voltage.
– Insert either the 12V connector plug or
the mains power plug into the appropriate
socket on the cool-box.
– Connect the 12V cigarette-lighter plug into
a suitable 12V socket, or insert the mains
plug into a suitable mains outlet.
– Set the selector switch to either the cooling
or the warming function. Th e appropriate
indicator light will come on.
– To compartmentalise the cool-box, the
partition may be inserted from above into
the 2 grooves on the inside.
– During periods of non-use, always switch
off the cool-box and disconnect the cable
last used from the power source.
Hints
Cooling
To achieve optimum cooling, the cool-box
should be fi lled with pre-chilled food and/or
beverages. Th
e food and beverages will then
be kept cool or be cooled down even further.
8