Garmin GPSMAP 496 - Manual (Page 154)

46 GPSMAP 496 Owner’s Manual
A
PPendIx
> M
essAges
no tide Stations for that area—no tide stations within 100 miles of the
area.
none Found—no data matched the search criteria.
off Course—you are off course by the distance set in the Off Course
Alarm.
proximity Memory Full—no additional proximity waypoints can be
saved.
proximity radius overlaps—the radius of two proximity waypoints
overlap.
route already Exists—you have entered a route name that already exists.
route Calculation Error—no route can be calculated.
route Memory Full—no additional routes can be saved.
route truncated—uploaded route from another device has more than 300
waypoints.
route Waypoint Memory Full—no additional route waypoints can be
saved.
Shallow Water—the water is shallower than the amount set in the Shallow
Water Alarm.
Sonar Failed Unit needs repair—there is an internal problem with the
unit. Contact Garmin Product Support to have the unit serviced.
Steep turn—approaching a turn that requires a bank angle in excess of 25
degrees to stay on course.
Sunrise, Switching to Day Mode—the unit is switching to Day Mode.
Sunset, Switching to night Mode—the unit is switching to Night Mode
track already Exists—a saved track with the same name already exists.
track Log Full—the track log is full and track recording was turned off.
To record more track points, you need to clear the track log and turn track
recording on.
track Memory Full—no more track data can be stored. Delete the old
track data to store the new data.
track truncated—a complete uploaded track will not fit in memory. The
oldest track log points have been deleted.
transducer Disconnected, Sonar turned off—the unit has no transducer
attached, has a bad cable/transducer, or has a disconnected transducer
cable.
transfer Complete—data transfer was completed.
USB Connected—the USB cable was recently plugged in.
User timer Expired—the Timer Alarm value has counted down to zero.
VnaV Cancelled—VNAV function has been cancelled due to a change in
the active route.
Water Speed Sensor is not Working—the speed sensor is not detected.
Check the connections.
Water temperature alarm—sonar has reported a temperature above,
below, inside, or outside the specified values(s).
Waypoint already Exists—a waypoint with the same name already exists.
Waypoint Memory Full—the unit has stored the maximum number of
waypoints.