Garmin GNC 300 - Manual (Page 59)

The third page available from the GNC 300’s WPT key is the user waypoint list,
which can be used to quickly scan, review, rename or delete user waypoints.
To display the user waypoint list:
1. Press
W
and use
O
to display the user waypoint list.
2. To scroll through the list, rotate
K
.
The total number of user waypoints is displayed at the top of the page, with user
waypoints listed two at a time in alphabetical order. The scrolling arrow prompt,
located at the top left of the page, will indicate which direction to scroll to view addi-
tional waypoints. The status of each waypoint, if applicable, will be displayed to the
right of the identifier. A status will appear when it is the active-to waypoint, part of an
active or stored route, or a proximity waypoint. To edit, rename or delete waypoints,
the cursor must highlight the desired waypoint.
To highlight a waypoint:
1. Press
C
twice and use
O
to highlight the desired waypoint.
To edit a highlighted waypoint:
1. Press
E
to obtain the waypoint position page. Edit the waypoint as described on pages
45-46. Note: The active-to waypoint cannot be edited.
To delete a waypoint from the list:
1. Highlight the desired waypoint and press
\
. Press
E
to confirm the deletion.
To rename a waypoint from the list:
1. Highlight the desired waypoint. Use
K
and
O
to enter a new
identifier for the waypoint.
2. Press
E
on the confirmation page to change the name, or press
\
to cancel. 49
REFERENCE
Route Copying and
Closest Pt of
Approach (CPA)
User Waypoint List
Renaming a user waypoint.
SECTION
3
WPT KEY
User Waypoint List
300 7/14/98 8:50 AM Page 49