Garmin StreetPilot 2650 - Manual (Page 73)

Appendix
63
Attaching the StreetPilot to the Base
These steps apply to both the non-skid friction mount base and the adhesive dash mount.
1. Slide the locking lever on the mounting base, to the left
(unlocked position).
2. Attach the StreetPilot to the mounting base by sliding
the disk on the bottom of the StreetPilot into the base
until it clicks into place.
3. Rotate the StreetPilot left or right until the desired angle
is achieved. Slide the locking lever to the right (lock) to
secure the StreetPilot to the base.
Adjusting the StreetPilot’s Viewing Angle
1. Tilt the StreetPilot forward or backward as needed. The mounting
bracket clicks as you adjust the tilt.
2. Rotate the entire StreetPilot by sliding the locking lever to the
left (unlocked position). Adjust the angle as desired and move
the lever back (right) to the locked position.
Removing the StreetPilot from the Base
1. Slide the locking lever (on the mounting base) to the left (unlocked position).
2. Press the release tab downward and slide the StreetPilot to the right.
Vehicle Installation
Unlock to adjust
left/right