Garmin GPSMAP 5215 - Manual (Page 64)

60 GPSMAP ® 4000/5000 Series Owner’s Manual
Device Configuration
Setting the Off Course Alarm
You can set an alarm to sound when you are off course by a specified distance.
1. From the Home screen, select Configure > Alarms > Navigation > off Course > on.
2. Enter the off-course distance that triggers the alarm.
3. Select Done.
System Alarms
Setting the Clock Alarm
You can set an alarm using the system (GPS) clock.
1. From the Home screen, select Configure > Alarms > System > Clock > on.
2. Enter the time that triggers the alarm.
3. Select Done.
Setting the Unit Voltage Alarm
You can set an alarm to sound when the battery reaches a specified low voltage.
1. From the Home screen, select Configure > Alarms > System > Unit Voltage > on.
2. Enter the voltage that triggers the alarm.
3. Select Done.
Setting the GPS Accuracy Error Alarm
You can set an alarm to sound when the GPS location accuracy falls outside the user-defined value.
1. From the Home screen, select Configure > Alarms > System > GPS Accuracy > on.
2. Enter the GPS location accuracy that triggers the alarm.
3. Select Done.
Setting the Total Fuel Onboard Alarm
The chartplotter must be connected to an external fuel sensor to capture fuel economy data.
You can set an alarm to sound when the total amount of remaining onboard fuel reaches the level you specify.
1. From the Home screen, select Configure > Alarms > Fuel > total Fuel onboard > on.
2. Enter the amount of fuel that triggers the alarm.
3. Select Done.
Collision Alarm
See “Setting the Safe-zone Collision Alarm” ( page 17 ).
Setting Sonar Alarms
See “Sonar Alarms” ( page 94 ).
Setting Weather Alarms
See the XM WX Satellite Weather ® and XM Satellite Radio Supplement (North America only).
Chartplotter Data Management
Copying Waypoints, Routes, and Tracks to a Chartplotter
Before you copy MapSource ® or HomePort ™ data to a chartplotter, you must complete the following actions:
• The first time that you use a memory card to copy HomePort or MapSource data to a chartplotter, you must
prepare the memory card by inserting it into the chartplotter and allowing the chartplotter to place a file on
it. This file provides information to HomePort or to MapSource to format the data.
• Check the MapSource version on your computer by clicking Help > About MapSource. If the software
version is older than 6.12.2, update to the current version by clicking Help > Check for Software
Updates, or go to www.garmin.com .