Garmin GPSMAP 2006C - Manual (Page 79)

70
Reference To select/deselect a main page:
1. Use the ARROW KEYPAD to highlight the box to the left of the page name. Press ENTER/MARK to select/
deselect that page. When a page is selected a ‘ ’ appears in the box. You must leave at least one page
checked.
You may also choose from one of the following SOFT KEY options:
• All Pages— selects all pages.
• Chart Plotter— selects Map page only.
• Nav Tools— selects Compass, Numbers, Highway, and Active Route pages only.
• Defaults— selects all pages.
To ‘Jump To’ a specific page:
1. Use the ARROW KEYPAD to highlight the ‘Jump To’ option to the right of the desired page and press
ENTER/MARK.
To set the First Page:
1. Use the ARROW KEYPAD to highlight the ‘First page’ option and press ENTER/MARK. Highlight the page
you wish to appear first and press ENTER/MARK.
Temp (Temperature) Tab — displays the water temperature log (if equipped with a GSD 20 Sonar
Module or receiving sonar NMEA input). The graph reads from right to left, so that the most recent tem-
perature measured is displayed on the far right side of the graph. The dotted lines within the graph indicate
intervals in the temperature scale and the duration of time.
The following settings are available:
• Temperature Scale — sets the temperature range (in degrees) for displaying the log. Select ‘Auto’
to have the unit automatically determine the best range, or select a span of 2, 4, 6, 8 or 10 degrees.
• Time Duration — sets how fast or slow the temperature log scrolls; the shorter the time duration,
the faster the temperature log scroll. Select a duration from 1 minute to 2.5 hours.
• Reset Auto Scale — resets the scale range for the temperature graph. This is useful when the scale
spans a large range due to extreme temperature changes. Only shows when Temp Scale is set to
‘Auto’.
Temp Tab
Main Menu: Pages/Temp Tabs