Garmin GPSMAP 2006C - Manual (Page 88)

79
Appendix B
Messages
Accuracy Alarm— The GPS accuracy has fallen outside of user-set value.
Alarm Clock— The alarm clock has sounded.
Alarm Voltage Too High— Specified voltage is too high, set to a lower value.
Alarm Voltage Too Low— Specified voltage is too low, set to a higher value.
Anchor Drag Alarm— You have drifted out of the specified distance range.
Approaching Waypoint— You are a specified alarm distance from a destination waypoint.
Arrival At Waypoint— You have arrived at the destination waypoint.
Battery Alarm—Specified amount of input voltage has been detected.
Can’t Unlock Maps— Data on data card is not unlocked for the unit. Contact your dealer or Garmin.
Database Error— Tried to use an invalid or unavailable database point.
Deep Water Alarm —Specified deep water alarm depth has been detected below the transducer.
Differential (DGPS) GPS Alarm —Unit has lost Differential GPS (DGPS) fix.
External Sonar Error Software Update Needed —GSD 20 is attached to unit and requires software
update. See www.garmin.com for software updates or contact Garmin.
External Sonar Connection Lost — Communication problems betwwen the GSD 20 and unit. Check
wiring connections. Contact your dealer or Garmin if problem persists.
Fish Alarm —Sonar has detected a fish of the specified size symbols(s).
GPS Antenna Failure, Antenna Needs Repair— GPS receiver problem. Contact your dealer or Garmin.
GPS Antenna Has Lost Its Stored Settings— GPS receiver problem. Contact your dealer or Garmin.
Lost Position From GPS Antenna— The unit has lost satellite signals. Check antenna connections or try
moving to a location with a clear view of the sky.
No DGPS Position— No differential correction data is available or not enough data is available to compute
a DGPS position.
The GPSMAP 2006/2010 uses an on-screen pop-up message system to alert you to unit operating char-
acteristics. Press the ENTER/MARK key to acknowledge and return to the page you were viewing.