Blue Ox BX4330 - Manual (Page 7)

BX4330
Acclaim ® Tow Bar
Operation Manual & Installation Instructions
292-2205 Rev J Page 7 of 7 4/23/13
CUSTOMER SERVICE COMMITMENT
Blue Ox® is committed to providing you with exceptional customer care throughout your lifetime
with our products. Our team is here to assist you with any questions you may have regarding the
performance of your product. Simply call (402) 385-3051 and you can speak with our customer care
team.
Additionally, please visit our website to see which rallies our Destination America team will be
attending. For a nominal fee, our service technician will service your towing system to ensure it’s in
proper working condition. Also, as a commitment to our customers, should you visit our factory, you
can stay at our full service Blue Ox® campground at no charge along with enjoying a factory tour.
Again, thank you for being our customer and for the confidence you have shown in the performance
of our products. It is because of customers like you we enjoy the success we have today.
© 2012 Blue Ox
One Mill Road, Industrial Park
Pender, Nebraska 68047
Phone: (402) 385-3051
Fax: (402) 385-3360
www.blueox.com
1. This tow bar requires periodic maintenance. It will be subjected to road dirt and weather during
use. The following tips will help maintain the condition of your new tow bar.
2. Keep the tow bar covered when not in use, on or off of the towing vehicle. This will cut down on
the dust and dirt build up on the legs and latches of the tow bar. A BX88156 tow bar cover is
recommended.
3. Periodically clean the entire surface of the tow bar with a mild soap and water solution. Wipe dry
with a clean cloth.
4. Check and replace any loose, worn or damaged bolts, rubber boots or cap plugs.
5. Check for cracked welds and loose bolts on the baseplate of the towed vehicle and the hitch on
the towing vehicle.
Lubrication
1. Approximately once per year or if it is difficult to move the legs in and out you should remove the
small cable ties holding the rubber boots on the legs and slide the boots back. Wipe clean each
inside leg and apply a light coat of multipurpose grease to insure smooth operation. Secure each
boot back in place with an 8” nylon cable tie.
Tow Bar Maintenance