Blue Ox SC2001 - Manual (Page 5)

© 2005 Blue Ox Division, Automatic Equipment Mfg. Co. • One Mill Road, Industrial Park
Pender, Nebraska 68047 • Phone 402-385-3051 • Fax 402-385-3360 • www.blueox.us
292-2676 4/05 Page 4 of 9
2. Align the square holes of the motorcycle deck (item 3) with the stinger weldment (item 1) holes, insert the
four 3/8-16 x 1" carriage bolts into the four holes and finger tighten the 3/8-16 nylon hex locking nuts on the
bottom side of stinger weldment. Insert the 3/8-16 x 2 1/2" carriage bolts through the square hole of the
deck, into the frame and tighten 3/8-16
nylon hex lock nuts with the 9/16" socket.
Using the 9/16" socket, tighten the four hex
nuts on the bottom side of stinger weldment.
Torque 3/8"-16 hex nuts to 33 ft. lbs.
Torque 7/16"-14 hex nuts to 54 ft. lbs.
NOTE: Carrier deck is shown as set up
for curb side loading, but can be assembled
with the track pointing either direction for
loading from left or right. Do not use a
washer on the head of the vertical
carriage bolts. The bolt head
should go through the square
openings of the deck in the
short outer tube section and
rest against the main tube.
NOTE: The head of the 7/16-14 x 2 3/4" cap
head screws are recessed into the 5/8" opening
of receiver and stinger sleeve. This will allow
stinger to be pulled to one side and eliminate
stinger to wobble.
о
о
2" RECEIVER
VEHICLES
8
3
11