Front panel controls electrical installation – DB Drive E5 HLC6 User Manual
Page 3
3
2
1
4
-2-
-3-
1
3
2
4
5
6
6
5
FRONT PANEL CONTROLS
ELECTRICAL INSTALLATION
Speaker-Level Inputs
- Six Speaker Level Inputs
12V Output Trigger
-
Gives you a separate 12 volt turn-on lead for external
amplifiers so there is no need to run a separate wire to the front of the car
Ground Isolation Selector
-
Occasionally alternator noise may appear in a
system because the source unit and amplifier are using different grounding schemes.
To help in this situation, we have provided alternative grounding connections. Make
sure your system is turned OFF before you move these jumpers.
Six Output Channels
-
Six output channels that can either run independently
or be summed together internally
Channel Summing
-
The E5 HLC6 internal jumpers allow installer to sum
selected channels into sub channels. This is especially useful for factory-installed
systems with actively crossed-over speaker systems.
Level Matching Controls
-
Allows the user to adjust the outputs on the E5 HLC6
independently to help insure proper level matching throughout the entire system.
AMPLIFIER
AMPLIFIER
Front
Speakers
RCA Connectors
Factory Installed
Radio
Speaker Level -4 Channel
Rear
Speakers
POWER
Summed
Separate
SUB
OUTPUT VOLUME
FRONT
OUTPUT VOLUME
REAR
OUTPUT VOLUME
SHORT
ISO
220
SUB
FRONT
REAR
OUTPUT
SUB REMOTE
LEVEL
SIX CHANNEL LINE OUTPUT CONVERTER
SUB
Summed
Separate
REAR
AMPLIFIER
Subwoofers
RCA Connectors
Factory Installed
Radio
Speaker Level -Signals
Sub
Rear
Front
POWER
Summed
Separate
SUB
OUTPUT VOLUME
FRONT
OUTPUT VOLUME
REAR
OUTPUT VOLUME
SHORT
ISO
220
SUB
FRONT
REAR
OUTPUT
SUB REMOTE
LEVEL
SIX CHANNEL LINE OUTPUT CONVERTER
SUB
Summed
Separate
REAR
AMPLIFIER
AMPLIFIER
Front
Speakers
Rear
Speakers