EVS IPDirector Version 6.2 - June 2013 IPEDIT User Manual - Manual (Page 201)

How to Delete a Swap or Mute Defined From and
to Given Points of a Track
To modify an audio swap or mute defined on a part of an audio track, proceed as follows:
1. In the general timeline display, click the Swap/Mute Zoom button on the right of
the track on which to add the swap or mute.
The track is displayed in Swap/Mute Zoom mode.
2. Select the swaps you want to delete in one of the following ways:
◦ Lasso the swap point(s) to select from right to left.
◦ Right-click the swap point(s) to select, keeping CTRL pressed for multiple
selections.
3. Right-click and select Delete Swap/Mute.
The Swap/Mute Configuration window opens.
4. Answer Yes to the message asking whether you want to delete the swaps or mutes.
The selected swaps or mutes are deleted.
6.14. Adjusting the Audio Volume on the
Timeline
6.14.1. Introduction
You can adjust the audio volume for each track, i.e. group of audio channels, of a timeline
by means of the Volume Automation mode.
Note
You cannot use the volume automation feature on timeline elements whose
speed is different than 100%.
6.14.2. Accessing and Leaving the Volume
Automation Mode
• To access the Volume Automation mode on a given track of the loaded timeline, click
the Volume Automation button on the right of the track display.
• To leave the Volume Automation mode, click the button.
IPDirector - Version 6.2 - User Manual - IPEdit
6. Timeline 189