EVS XT2 Version 11.01 - November 2012 Configuration Manual - Manual (Page 15)

When Starting the EVS Server After Initial Configuration
After the initial configuration, you will select a configuration line and press ENTER to run
the server in this configuration. See section "Launching a Configuration" on page 12. As
soon as the EVS server is launched in a configuration, it starts the loop recording process.
1.4. Accessing the Web-Based Interface
Prerequisite
When the EVS server is started, you can access the web-based interface of the Multicam
Setup application for that EVS server from any machine (PC or server) that is on the same
network range as the EVS server. You can use any browser to open the web-based
interface.
Procedure
To be able to open the web-based interface in a browser, you need to know the IP address
of the PC LAN of the EVS server. See section "Setting the Server LAN PC Address" on
page 25 for more information.
In your browser, enter the following URL: http://xxx.xxx.xxx.xxx/cfgweb/ where the
crosses correspond to the PC LAN IP address of the EVS server you want to access.
XT2 Server - Version 11.01 - Configuration Manual
1. Introduction 5