EVS Xfile Version 2.12 - July 2009 User Manual - Manual (Page 22)

XFile Version 2.12 – User Manual
EVS Broadcast Equipment – July 2009
Issue 2.12.D
21
If the values are coherent, press START: the System Config field is
replaced by the Session Config field.
3.2.2 S
TATUS
A
REA
The aim of this area is to check the hardware validity, the remaining
capacity of disks and to verify the compatibility between the software, the
drivers and the data recorded.
The system automatically starts the test processing. One after the other, the
different stages of the boot sequence are displayed in the Status window.
If an error occurs during one stage, write the message down and contact
EVS staff for support.
The last test is the connection to the XNet. If this stage is successful, the
XFile is ready to operate.
Press the Start button again to enter the application.
3.2.3 A
UTOMATIC
P
ROCESSES
A
T
S
TARTUP
After the startup, the system automatically starts two operations: the
Scanning Disk process and the Scanning Network process.
Those operations might last a few seconds depending on the number of clips
present on disk and the number of clips present on the XNet.