EVS Xfile Version 2.12 - July 2009 User Manual - Manual (Page 85)

Issue 2.12.D XFile Version 2.12 – User Manual
EVS Broadcast Equipment – July 2009
84
Important
The Fast Publish command will disconnect the XFile from the XNet
and then re-connect the XFile to the XNet. During this operation,
the Multicam database is updated with the new publish list of the
XFile.
¨ This command will stop the current playbacks of XFILE clips.
¨ This command will make ‘unavailable’ the XFILE clips included
into a playlist, unless the original UmID is kept, if configured in
User Parameters. Refer to section ‘Parameter for Publish’ on page
47.
3.7.3 H
OW TO
U
N
-
PUBLISH A
C
LIP
When you work with Online publish mode, you can remove published clips
from the XNet list. To do so, proceed as follows:
1. Select the clip(s) from the XNet list.
2. Press Remove.
Clips are highlighted in light red in the XNet list when the remove
operation is scheduled and they disappeared from the XNet list when
the operation is completed.
The counter and the Publish column in the XFile list are then updated.