EVS MulticamLSM Version 10.01 - October 2009 Configuration Manual - Manual (Page 19)

Issue 10.01.I EVS Multicam Version 10.01 – Configuration Manual
EVS Broadcast Equipment SA – October 2009
12
Possible Values
The values can be the following:
• LTC LTC timecode, which is automatically stored in the LTC table. It is
specified in the LTC field
• USER User-defined timecode, which is stored in the USER TC table and
specified in the USER field.
Timecode Colour on the OSD
Depending on the value selected for this setting, the timecode displayed at the
bottom of the user’s OSD will have a different colour:
• If the LTC timecode is selected, the timecode colour will be white.
• If the USER timecode is selected, the timecode colour will be yellow.
H
OW TO
S
ETUP THE
P
RIMARY
TC
AND
U
SER
F
IELDS
To set up the primary TC or VITC field, proceed as follows:
1. Press SHIFT-F2 to open the Setup screen.
2. Use the <TAB> key to position the cursor on the field to edit.
3. Use the right and left arrows to go through the possible values for that field.
The value defined when you leave the field will be saved.