Edit all, Insert, Speed – EVS XTnano Version 11.01 - November 2012 Operation Manual User Manual
Page 79: Fx dur, Effect, Delete
nano series Servers - Version 11.01 – Operating Manual
EVS Broadcast Equipment SA – November 2012
Issue
11.01.C
71
clip, simply browse to the requested clip, then select a function from the menu displayed
above and use the control lever to adjust to the desired value (when applicable).
Edit All
If you want to edit all clips of the playlist at the same time, select
Edit All (SHIFT+D)
before you perform the requested editing action with one of the following playlist
commands:
Speed, Effect, FX Dur.
Insert
The
Insert function (A key) allows the operator to insert a clip into the playlist. The same
operation can be achieved using the
TAKE key.
See also the section 9.9.5 ‘How to Insert Clips into a Playlist’, on page 73.
Speed
The
Speed function (B key) allows defining the speed at which one or all clips of a playlist
will be played. Select the playback speed of the clip with the lever, then press
ENTER to
validate. Values are ‘Unknown’ and from 0 to 100%.
Operators have access to the secondary lever control like when clips are replayed. While
editing the speed of a clip, pressing SHIFT+Lever on the Remote allows to access the
secondary lever speed defined in the menu.
FX Dur
The
FX Dur function (C key) sets the duration of the transition effect. The default value
that initially appears is determined by the value set in the
Setup menu. The effect
duration will affect the transition at the beginning of the selected clip. Use the lever to
adjust the value, then press
ENTER to confirm.
Effect
The
Effect function (SHIFT+C key) is used to select the type of transition effect
(Mix/Wipe/Cut/Fade). Move the lever to set the type of effect, when
Effect is highlighted.
Press
ENTER to validate.
For more information on the effects types, refer to the section 9.14 ‘Transition Effects’, on
page 84.
Delete
The
Delete function allows the operator to quickly edit a playlist by removing the selected
clip. The clip that has been «cut» can then be inserted into another location. This clip is
displayed on the second PRV output. To insert it at another position in the playlist, simply
go to that position using the jog dial and press the
Insert key (or TAKE).