EVS XT2 Version 11.01 - November 2012 Configuration Manual - Manual (Page 68)

The following principles apply to EVS servers equipped with V3X boards:
• The primary links of the V3X boards mentioned in the tables of this section correspond
to the upper connectors of a codec module.
◦ J8 for IN connectors
◦ J7 for OUT connectors (J6 is also equivalent to J7)
• The secondary links of the V3X boards correspond to the middle connectors of a
codec module:
◦ J5 for IN connectors
◦ J3 for OUT connectors
Clip and Record Train Compatibility on XT2+ Servers
• Clips are compatible across all Multicam configurations including Super LSM.
• Record trains are also compatible as long as the number of record channels (cameras)
is not increased in LSM mode.
Example
◦ SuperLSM ® 2CAM (Fx): Record trains are lost.
◦ 4CAM (Fx) ® 3CAM (Cut): Record trains are kept.
• Record trains are always kept in Spotbox mode (all modes except LSM), even when
the number of record trains is increased.
XT2+ Server - Version 11.01 - Configuration Manual
3. Multicam Configuration 58