EVS XSense Version 11.02 - July 2013 Operating Manual - Manual (Page 83)

5.5. Operations on Playlists
5.5.1. Setting and Loading Playlists
Introduction
A distinction is made between setting and loading a playlist:
• When you load a playlist, you actually load it on a given player channel either to edit it
or to play it out.
• When you set the current playlist, you access the playlist location on the server but
you do not load it on a player channel. Thus you can insert clips directly in the current
playlist without having to load it onto a channel.
Note
At Multicam startup, the current playlist is automatically playlist 11,that is the
playlist 1 on bank 10 of page 1.
How to Set the Current Playlist
In the Remote Panel Interface
To set the current playlist, proceed as follows:
1. Only if you want to select a distant playlist, first press SHIFT+Network then press the
F_ key corresponding to the server on which the playlist is located.
2. Press SHIFT+Page+F_ key to select the page in which the desired playlist is located.
3. Press SHIFT+F10 to select the playlist bank.
4. Press F_ key to select the desired playlist.
5. Press ENTER to confirm.
OPERATION MANUAL XSense 11.02
5. Playlist Management 75