Focus Foodservice COMMERCIAL COFFEEMAKERS es - Manual (Page 4)

English - 4
5. Place the cover on the coffeemaker and turn to lock into the handle slots. Note
the arrows on the cover for correct direction. To reduce coffee spills, especially if
the coffeemaker is tipped over, make sure that the cover has been turned until it
is completely locked into the handle slots. Note: Moving an appliance containing
hot liquids is not recommended. If you must move the coffeemaker, extreme
caution should be used. The cover only temporarily reduces coffee from spilling
if the coffeemaker is tipped over.
6. Plug the cord into a 120 volt, AC grounded electric outlet ONLY. Set the
“ON/OFF” switch to “ON”. The “ON/OFF” switch will be illuminated. Do not plug
into an outlet or attempt to operate the coffeemaker empty.
7. The coffeemaker will stop perking automatically (each cup requires no longer
than 1 minute brewing time). As coffee is brewing, the yellow
“Brew” light will be
illuminated. Coffee is ready when the green
“Ready” light is illuminated. Coffee
will remain at serving temperature as long as the coffeemaker is plugged in (and
the switch is in the
“ON” position). Do not dispense coffee until the green
“Ready” light is illuminated.
8. To serve coffee directly into a cup, use your cup to carefully press against the
lower lever to dispense coffee. Gently pull the cup back when the cup is nearly
full to release the lever and stop the flow of coffee. Or, press the top lever down
to begin flow, and gently release when cup is ¾ full.
For continuous flow when filling a coffee carafe, press the top lever down until it
locks in the open position. Lift the lever upwards to the upright position when the
carafe is filled. Note: Do not use the lever lock when filling a single cup of coffee.
9. When coffee can no longer be seen in the view window, turn the
switch “OFF”
and unplug the cord from the electrical outlet. Note: Liquid must always cover
the inside bottom of the appliance at all times. Falling below the minimum level
could cause overheating and damage to internal components and will void the
warranty.
10. After every use, completely empty
and follow “Cleaning Instructions” to clean
your coffeemaker before using again. Do not let water or coffee sit in the
coffeemaker overnight.
Note:
A small amount of smoke or odor may occur upon heating due to the
release of manufacturing oils
– this is normal.
Some minor expansion or contraction sounds may occur during heating and
cooling
– this is normal.