Philips HR1853 - Manual (Page 9)

3 Clean these parts with a cleaning brush in hot water with some washing-up liquid and rinse
them under the tap.
Note: Use a soft brush to clean the filter.
Note: You can also clean all parts except the motor unit in the dishwasher.
4 Clean the motor unit with a damp cloth.
Disposal
Do not throw away the appliance with the normal household waste at the end of its life, but
hand it in at an official collection point for recycling. By doing this, you help to preserve the
environment (Fig. 8).
guarantee & service
If you need information or if you have a problem, please visit the Philips website at www.philips.com
or contact the Philips Customer Care Centre in your country (you find its phone number in the
worldwide guarantee leaflet). If there is no Customer Care Centre in your country, go to your local
Philips dealer or contact the Service Department of Philips Domestic Appliances and Personal Care
BV.
troubleshooting
This chapter summarises the most common problems you could encounter with the appliance. If
you are unable to solve the problem with the information below, contact the Customer Care
Centre in your country.
Problem Solution
The appliance does not work. The appliance is equipped with a safety system. It does not work
when the parts have not been mounted properly. Make sure
the control knob is set to ‘off’. Then check whether the parts are
assembled in the right way and the lid is properly locked in place
with the clamps.
The motor unit gives off an
unpleasant smell the first few
times the appliance is used.
This is not unusual. If the appliance continues to give off this smell
after you have used it a few times, make sure you do not process
too large quantities. Also make sure you do not let the appliance
run too long.
The appliance makes a lot of
noise, gives off an unpleasant
smell, is too hot to touch,
gives off smoke etc.
Switch off the appliance and unplug it. Go to the nearest Philips
service centre or your dealer for assistance.
The filter is blocked. Switch off the appliance, clean the feeding tube and the filter and
process a smaller quantity.
The filter touches the feeding
tube or vibrates strongly
during processing.
Switch off the appliance and unplug it. Check if the filter is
properly placed in the juice collector. The ribs in the bottom of
the filter should fit properly onto the driving shaft. Check if the
filter is damaged. Cracks, crazes, a loose grating disc or other
irregularities may cause malfunction.
-
EnglisH 9