High Lifter Lift Kit for Honda Rancher 400AT (03-07) - Manual (Page 6)

Front Installation (Front View)
This lift kit contains the following parts:
Lift Kit Brackets
7
Lift Kit (Spacers) 5
10mm x 55mm Bolt 4
10mm Nut 4
10mm Washer 8
10mm x 80mm Bolt 2
10mm Nut x 1.25 pitch 2
6mm x 16mm Flange Bolt 2
Front Lift
1) Chock rear wheels and set parking brake.
2) Loosen front wheel lug nuts.
3) Place jack under center of ATV front-end and lift until front wheels clear the
ground. Be careful to support ATV properly so that it is securely supported but so
that A-arms and shocks can droop to full extension.
4) Remove front wheels and remove bottom shock bolts. Loosen top shock bolt.
5) With the diagonal cut corners being the top of the bracket “A”, slide the bottom of
the lift bracket over the A-arm shock mount with the larger notch on the other end
of bracket “A” facing toward the outside and the front tire. Place one spacer ”F”
between the bottom holes of the bracket and shock mounts and insert new
10mmx55mm bolt through the spacer and secure with 10mm lock nut