KC HiLiTES KC #7307 Light Bracket for 1½, 1¾ or 2 inch Tubular Bar Installation - Manual

Thanks for choosing a KC HiLiTES product. We take pride in building the highest quality, best engineered systems possible.
Your satisfaction with our product is important, so if you have any questions, please call our customer service line at 800-
528-0950.
Parts Included:
1 - Light bracket (2 pieces) 4 - Allen (3/16” head) bolts ¼”-20 x 1½”
4 - Square nuts ¼”-20 4 - Washers ¼”
4 - Rubber spacers 2 ¾”x 2 5/16” x 1/8” 1 - Instructions
Installation
For 1½” Bar - You must use all four spacers. Cut ¼” off of the longer length
on two of the spacers. Set these aside. Remove the paper backing on the
two uncut spacers. Push one into each of the two halves of the bracket so
they do not overhang any of the edges. Now remove the paper from the two
cut spacers and put one in each of the two halves also allowing no
overhang.
For 1¾” Bar - You will only use two of the spacers. Remove paper and align
one in each half of the bracket as described above.
For 2” Bar - No spacers needed
Continue Installation
1. Fit both halves around the bar.
2. Slide a lock washer onto one of the bolts and insert it through one of the bottom
holes. Add a nut and tighten bolt only enough to hold nut in place.
3. Loosely add the other three bolts with washers and nuts.
4. Position and level the bracket to fit your needs. Tighten all bolts evenly by
Installation Instructions
KC 7307 Light Bracket for
1½, 1¾ or 2 inch Tubular Bar
KC HiLiTES, Inc. 2843 W. Avenida de Luces, Williams, Arizona 86046-0155 * 800-528-0950 * www.kchilites.com KC3266UW - 070909
See
de
tails
on
ou
r we
bsit
e a
t
ww w.k
chil
ites
.com 23
Yea
r W
arra
nty