Manhattan 176767 SATA 1.5 Gb_s RAID Controller PCI Card - Manual - Manual (Page 7)

1. On the Windows setup screen, press F6 to specify and add the driver.
2. Insert the driver CD; press S; press Enter.
3. Select “Silicon Image Sil-3x12 SATA Raid Controller Driver”; press Enter.
4. Press Enter to continue; follow on-screen instructions to complete the
installation.
To Add Windows 2000 Driver on Original Booting Device
NOTE: Once the SATA 150 RAID Controller PCI Card and attached
drives are configured, boot up Windows.
1. At the Found New Hardware Wizard, click “Next.”
2. Select “Search for a suitable driver for my device (recommended)”:
click “Next.”
3. Insert the driver CD in the CD-ROM drive. Check “Specify a location”;
uncheck the other boxes; click “Next.”
4. Enter “E:\” (or use whatever letter denotes your CD-ROM drive); click
“Browse.”
5. Highlight a location (for example, E:\SATA Raid_2Port\Sil3x12\
Win98_me_2000_xp_nt4.0\driver); click “Open”; click “OK.” NOTE: If
the message “Digital Signature Not Found” displays, click “Yes.” If
further prompted for the Windows CD: insert the CD; click “OK”; enter
“E:\I386” (or use whatever letter denotes your CD-ROM drive); click
“OK”; click “Finish.”
6. Click “Finish.”
For New Windows XP Systems
NOTE: Before installation, copy all the files under directory E:\SATA
Raid_2Port\Sil3x12\Win98_me_2000_xp_nt4.0\driver\*.* to a blank
disk. Once the SATA 150 RAID Controller PCI Card and attached drives
are configured, follow Microsoft procedures to install Windows.
1. On the Windows setup screen, press F6 to specify and add the driver.
2. Insert the driver CD; press S; press Enter.
3. Select “Silicon Image Sil-3x12 SATA Raid Controller Driver”; press Enter.
4. Press Enter to continue; follow on-screen instructions to complete the
installation. NOTE: When the Software Installation and Hardware
Installation warnings display, click “Yes.”