Philips HD6180 - Manual (Page 14)

Problem Possible cause Solution
The water reservoir has
not been inserted
properly.
Check whether the water reservoir has been
inserted properly (you hear a click).
The PreClean
function cannot
be activated.
More than 30 seconds
elapsed between the
moment you switched on
the appliance and the
moment you pressed the
PreClean button. In this
case, the PreClean
function is not activated.
Set the on/off switch to ‘I’ to switch on the
appliance. Then press the PreClean button
within 30 seconds.
Oil or fat spills
over the edge of
the fryer during
frying.
There is too much oil or
fat in the fryer.
Make sure the oil or fat in the fryer does not
exceed the maximum level.
The food contains too
much moisture.
Dry the food thoroughly before you fry it. Then
fry the food according to the instructions in this
user manual.
There is too much food in
the frying basket.
Do not fry more food at one time than the
quantities mentioned in the food table at the
end of this booklet.
The oil or fat
foams strongly
during frying.
The food contains too
much moisture.
Dry the food thoroughly before you fry it.
The type of oil or fat used
is unsuitable for deep
frying food.
Never mix different types of oil or fat and use
oil or liquid fat that contains an antifoam agent.
The fryer does
not work.
The inner bowl has not
been placed properly in
the fryer.
Move the inner bowl slightly to and fro in the
appliance to ensure that it is in the correct
position.
The thermal safety cut-out
has switched off the
appliance.
Let the oil or fat cool down. Carefully press the
reset button at the front of the fryer (see
chapter ‘Safety’).
If the fryer still does not work, go to your Philips
dealer or a service centre authorised by Philips.
The fryer makes
plopping sounds
that are louder
than usual (it is
normal for the
fryer to make
soft plopping
sounds).
The food contains too
much moisture.
Dry the food thoroughly before you fry it.
EnglisH 1