页 17, System setup – Naxa ND-851 User Manual
Page 17
2. If Screen Saver is selected, press the Direction button
►to enter. Press the Direction buttons
Press the SETUP button to save the setting and exit. When set to On, the screen saver will come on when the
unit stops or the image is paused for approximately ten minutes. When set to is Off, the screen saver will
not come on.
▲, ▼ to select On or Off as desired then press the Enter button to confirm the selection.
-16-
SYSTEM SETUP
3. If TV system is selected, press the Direction button
to enter. Press the Direction buttons , to select the
format of output signals to PAL, NTSC or AUTO. Then press the Enter button to confirm the selection.
Press the
SET UP button to save the setting and exit.
Set it to P
if the color system of your TV is PAL.
AL
Set it to AUTO if the color system of your TV is multi.
Notes:
Set it to NTSC if the color system of your TV is NTSC. (Default setting. The TV signals in US, Canada and
Mexico is NTSC).
select video output modes to
Notes:
~ Set to
if you connected the TV via the AV
on the player and AV
on the TV as the figure on page 10.
~ Set to YUV if you connected the TV via the YUV jack on the player and YUV IN jacks on the TV as the
figure on page 10.
~ Set to YUV P-SCAN if you connected the TV via the YUV jack on the player and YUV IN jacks on the TV (TV also
set
to Progressive Video input mode)
as the figure on page 10.
AV,YUV or YUV P-SCAN.
AV
cable
cable
4. If Video output is selected, press the Direction button to enter. Press the Direction buttons , to
In Audio Setup Page:
Down Mix
If Down Mix is selected, press the Direction button ►to enter. Press the Direction buttons ▲,▼
to select "Lo/Ro" or "Lt/Rt" to set the rear audio channels mode as desired. Press the SETUP button
to save the setting and exit.
5. If Brightness is selected, press the direction button ( ) to enter. Press the direction buttons ( , ) to select
brightness
level from Normal,Bright or Soft as desired. Then press the Enter button to confirm the selection.
Press the SETUP button
to save the setting and exit.
6. If Contrast is selected, press the direction button ( ) to enter. Press the direction buttons ( , ) to select
contrast level
button to save the setting and exit.
from -4 to +4 as desired. Then press the Enter button to confirm the selection. Press the SETUP