Naxa NPB-429 - Manual (Page 5)

4
REMOTE CONTROL OPERATION
To operate the unit with the remote control, point the
remote handset at the remote sensor on the front panel and
press the appropriate button on the remote handset.
The remote works best within a range of 6 ~ 7 meters from
the front panel and on an angle of 30 degrees. Bright
sunlight or room light conditions can interfere with the
remote control. If the remote operation is unsatisfactory or
stops working entirely, first try replacing the remote
batteries, then try reducing the room lighting conditions.
LITHIUM BATTERY INSTALLATION OF REMOTE CONTROL
 The remote control includes one CR2025(3V) lithium battery.
 To replace the battery, gently push the clasp to the right direction
according to the instruction and then pull out the battery compartment.
Take the drained battery out and install a new lithium battery(CR-2025)
in the compartment with the positive polarity upwarded. Then push the
compartment back to its position with a “ click ” sound indicating installation
finished
POWER SUPPLY
1. DC OPERATION
– REMOVE THE BATTERY COMPARTMENT DOOR.
– INSERT 8 PIECES UM-1 (D SIZE) BATTERIES INTO THE BATTERY COMPARTMENT WITH
BATTERY POLARITY POSITIONED AS INDICATED.
– CLOSE THE BATTERY COMPARTMENT DOOR.
CAUTION:
Remove batteries if they are flat or not being used for a long period of time.
Batteries contain chemical substances, so they should be disposed of properly.
2. AC OPERATION
- PLUG THE AC LINE CORD INTO ANY NORMAL HOUSEHOLD AS MAINS OUTLET IN
CORRECT VOLTAGE AND THE MAINS SOCKET.
- THE BATTERIES WILL BE AUTOMATICALLY DISCONNECTED.
- FOR DUAL VOLTAGE VERSION, MAKE SURE THAT THE AC VOLTAGE SELECTOR
(LOCATED ON THE BOTTOM OF THE UNIT) IS SWITCHED TO YOUR LOCAL VOLTAGE.
BASIC FUNCTION
SPEAKER CONNECTION
Before switching on the unit, please connect the two speakers first! Plug each speaker to the
corresponding speaker jack on the back panel of the main unit. Make sure that the left speaker is plug to
the left pair of speaker terminals and the right speaker to the right pair of speaker terminals. Also make
sure that the left wires are plug to the “L” jack and the right wires to the “R” jack.
SWITCHING ON THE UNIT
Note: Before switching on the unit, Please make sure that all connections have been ready.
When the unit is switched on, the STANDBY indicator would illuminate.
Press the STANDBY button to switch the unit on. Press the FUNC. button to RADIO, AUX ,CD or USB
to enter operating.