Naxa NPB-429 - Manual (Page 7)

6
Note:
 Make sure the disc is stopped before opening the CD DOOR.
 To ensure good system performance; wait until the unit completely reads the disc before proceeding.
 If no disc loaded into the tray, or the disc is unreadable, the display will show “ no ”.
PLAYING A DISC
1. The unit will start playback from track 1 after reading finished. The “ ” indicator would be
shown on the display.
To interrupt playback, press the button. The “ ” indicator and the current track will flash
on the display.
To resume playback, press the button again.
2. To stop playback, press the STOP button, the total number of tracks appears on the display.
SELECTING A DESIRED TRACK/PASSAGE/FOLDER
To select a desired track
 Press the CD SKIP UP/DOWN or TUNING UP/DOWN button repeatedly in stop mode or during
play until the desired track appears on the display.
 Press the button to start play.
To search for a particular passage during playback (track scanning at high speed)
Press and hold CD SKIP UP/DOWN or TUNING UP/DOWN button to scan the current playing track at
high speed until desired point (passage) appears, then release the button. Playback will start from this
point.
To select a song which track number exceeds 10
To select a song/track which number exceeds 10, Press the FOLD.+/+10 or FOLD.-/-10 button to skip
forward or backward 10 tracks, then press the SKIP UP or SKIP DOWN button to select desired track. For
example: to select the 17
th track from the 1 st track, press FOLD+/+10 and FOLD-/-10 button, and then the
SKIP UP button six times immediately.
To select a desired folder（for MP3 disc that contains more than one folder）
To select a desired folder during playback, press and hold the FOLD.+/+10 or FOLD.-/-10 button to
next/previous folder.
PROGRAM TRACKS
Programming tracks of disc are possible when playback is stopped. Up to CD 20 tracks / MP3 99 tracks
can be stored in the memory in any order.
1． In stop mode, press the MEM button to enter program setting, the display will show and P01 .
2． Press the SKIP UP button to select the first desired track to be programmed. (example: track 2)
3． Press the MEM button to enter. The display would show and P02.
4． Repeat steps 2 & 3 to store other desired tracks until all tracks are programmed.
5． Press the button to start playback from the first programmed track.
6． Press the STOP button to stop program playback.
To Erase the Memory (Program)
To clear the program, you may:
Press STOP button and change to other function, or open the CD compartment