Naxa NDL-400 - Manual (Page 5)

4
Basic connection
—
—
—
—
—
—
—
It is recommended to be connected to a multi-system TV.
Ensure that this player and other equipment to be connected
to the unit are in the standby or off mode and disconnect the
AC power cords before commencing connection.
Do not block ventilation holes of any piece of the equipment
and arrange them so that air can circulate freely.
Read through the instructions before connecting other
equipment.
Ensure that you observe the color coding when connecting
audio, video cables.
During DVD play, the TV volume may be at a lower level
than during TV broadcasts, etc. If this is the case, adjust the
volume to the desired level.
If the DVD/CD player is connected to the TV through a video
cassette recorder, the picture may not be played back
normally with some DVDs. If this is the case, do not connect
the player via the VCR.
Note:
Connecting to a stereo TV set
To power outlet
AC power cord
1. SCREEN OFF/ON button
2. MUTE button
3. P MODE button
4. GUIDE button
5. TV MENU button
6. REPEAT button
7. PLAY button
8. SUBTITLE button
9. AUDIO button
10. PAUSE/STEP button
11. ANGLE/PROGRAM
button
12. ZOOM/SLOW button
13. TV/DVD button
14. MTS button
15. DISPLAY button
16. SETUP button
17. P/N button
18. NUMERIC buttons
19. DVD MENU button
20. STOP&DVD/USB/SD button
21. OK button
22. NAVIGATION buttons
23. TITLE button
24. NEXT/F.FWD button
25. PREV/ F.BWD button
26. SEARCH button
27. CC button
Remote control unit
To video input connector (yellow)
To audio input connectors (red, white)
Video/audio cable
R L
1
2
3
4
5
6
7
8
9
10
11
12
13
14
27
15
16
17
18
19
20
21
22
23
24
25
26
12V DC JACK
DC 12V JACK (Center is positive) in 1.7mm (inner diameter)
type.
To connect external power source of an AC adaptor or a car
adaptor.
Please make sure that the DC voltage is 12V and with correct
polarity as per below.
Center pin is positive
Connecting the Aerial to the player
Aerial input
CABLE
Optional