Naxa NDL-254 - Manual (Page 5)

4
Basic connection
—
—
—
—
—
—
—
It is recommended to be connected to a multi-system TV.
Ensure that this player and other equipment to be connected
to the unit are in the standby or off mode and disconnect the
AC power cords before commencing connection.
Do not block ventilation holes of any piece of the equipment
and arrange them so that air can circulate freely.
Read through the instructions before connecting other
equipment.
Ensure that you observe the color coding when connecting
audio, video cables.
During DVD play, the TV volume may be at a lower level
than during TV broadcasts, etc. If this is the case, adjust the
volume to the desired level.
If the DVD/CD player is connected to the TV through a video
cassette recorder, the picture may not be played back
normally with some DVDs. If this is the case, do not connect
the player via the VCR.
Note:
Connecting to a stereo TV set
12V DC JACK (OPTIONAL)
DC 12V JACK (Center is positive) in 2mm (inner diameter) type.
To connect external power source of an AC adaptor or a car
adaptor.
Please make sure that the DC voltage is 12V and with correct
polarity as per below.
Center pin is positive
Connecting the Aerial to the player
To power outlet
AC power cord
To video input connector (yellow)
To audio input connectors (red, white)
Video/audio cable
RL
Aerial input
CABLE
Optional
OPERATIONS
PREPARATION
MUTE
REPEAT BUTTON
SWITCH TV SYSTEM
Power on the TV set and select video input mode.
Power on the audio system which is connected to the player.
Press NEXT or PREV button once during play to skip a chapter
(DVD) or a track (CD) ahead or backwards.
During playback, press and hold FAST FORWARD button or
FAST REWIND button several times to scan the disc forward or
backward at X2, X4, X8, X20 normal speed.
Press PLAY button to resume normal play.
During playback, press MUTE button to shut off the audio
output, press it again resume normal play.
Press STOP button during playback to stop playback; the player
activates its resume function when STOP is pressed in STOP
mode; press PLAY button again, playback resumes at the point
it stopped previously; open the disc tray or press the STOP
button one more time to clear the resume function.
Press REPEAT button during play, it will repeat play one
chapter/title or repeat all (for DVD disc), or repeat play a track
or all tracks (CD), or repeat the specified points (A-B).
During playback, press P/N button to switch TV system directly.
GET STARTED
ADJUST THE VOLUME
SKIP AHEAD OR BACK
1. Rotate the FUNCTION CONTROL to TV/DVD position.
2. Lift CD cover to open the disc tray.
3. Place a disc onto the disc tray.
4. Close the disc tray and the playback starts automatically.
5. When a menu screen appears on the TV, move the navigation
buttons or press the numeric buttons to select a preferred track
number, then press OK button to start playback.
6. Slide the function switch to OFF position to turn off the unit.
Note: Sometimes it is necessary to use TV/DVD button on the
remote or MODE/TV MENU on the unit to switch to DVD mode.
The procedures as following: Press TV/DVD button on the
remote or press and hold MODE/TV MENU button on the unit
until a prompt shows on the screen, then use navigation button
to highlight DVD and press OK Button to enter DVD mode.
Turn VOLUME CONTROL to increase or reduce the volume.
Press SLOW button on the remote control during playback, the
disc will be played at 1/ 2 normal speed at first, each time this
button is pressed, the play speed becomes slower (down to 1/7
normal speed.)
Press PLAY button, normal play will resume.
RAPID ADVANCE/REVERSE
STOP PLAYBACK
SLOW-MOTION PLAY (DVD)