Ohaus CARAT PLUS PRECISION JEWELRY BALANCES 2nd RS232 Serial Interface Kit Manual multi - Manual (Page 3)

2
nd
RS232 Serial Interface Kit EN-1
1. INTRODUCTION
This RS232 Serial Interface Kit P/N 80850092 provides a second RS232 serial
interface for the Adventurer Pro balances. Please read this manual completely
before installation and operation.
READ ALL SAFETY WARNINGS BEFORE INSTALLING,
MAKING CONNECTIONS, OR SERVICING THE BALANCE.
FAILURE TO COMPLY WITH THESE WARNINGS COULD
RESULT IN PERSONAL INJURY AND/OR PROPERTY
DAMAGE. RETAIN ALL INSTRUCTIONS FOR FUTURE
REFERENCE.
1.1 Contents
• RS232 Printed Circuit Board (PCB)
• PCB Cable
• RS232 Cable
• Protective Cone Cover
• Screws (2) to secure the RS232
PCB
2. INSTALLATION
2.1 Safety Precautions
• Disconnect the balance from the mains power supply and remove any installed
batteries before beginning installation.
• Internal components, such as the load cell and printed circuit boards (PCB), are
delicate and need to be handled with care.
• Do not subject the internal components to static electricity discharge.
• The PCB’s should be handled by grasping the edges only and never placing
fingers on any of the runs or traces.
2.2 Installation
The Adventurer Pro series comes in different configurations (see Figures 1A-B-C).
Disassemble/assemble the balance according to the configuration that matches
your model.
Tools required (depending on model): Philips screwdriver or Torx driver T10 & T20.