Ohaus RANGER ADVANCED COMPACT COUNTING SCALES Manual en User Manual
Ohaus Scales
Advertising
Table of contents
Document Outline
- User manual
- Table of contents
- 1 Introduction
- 2 Operation
- 2.1 Switching on and off
- 2.2 Zeroing / Zero point correction
- 2.3 Simple weighing
- 2.4 Weighing with tare
- 2.5 Displaying the capacity available
- 2.6 Dynamic weighing
- 2.7 Weighing-in to a target weight and checkweighing
- 2.8 Working with identifications
- 2.9 Printing results
- 2.10 Displaying info
- 2.11 Switching scales
- 2.12 Totalising
- 2.13 Cleaning
- 3 Counting
- 3.1 Counting parts into a container
- 3.2 Counting parts out of a container
- 3.3 Counting with variable reference quantity
- 3.4 Counting with minimum accuracy
- 3.5 Reference optimization
- 3.6 Counting with automatic reference determination
- 3.7 Counting with a known average piece weight
- 3.8 Counting by calling up a saved average piece weight
- 3.9 Counting by calling up a saved target quantity
- 3.10 Counting with two scales
- 4 Settings in the menu
- 4.1 Operating the menu
- 4.2 Overview
- 4.3 Scale settings (SCALE)
- 4.3.1 SCALE1/SCALE2 - Selecting scale
- 4.3.2 CAL - calibration (adjustment)
- 4.3.3 DISPLAY - weighing unit and display accuracy
- 4.3.4 TARE - tare function
- 4.3.5 ZERO - automatic zero update
- 4.3.6 RESTART - automatic saving of zero point and tare value
- 4.3.7 FILTER - adaptation to the ambient conditions and the weighing type
- 4.3.8 FACT - automatic temperature-dependent adjustment
- 4.3.9 MIN.WEIG - minimum weight
- 4.3.10 RESET - resetting scale settings to factory settings
- 4.4 Application settings (APPLICATION)
- 4.5 Terminal settings (TERMINAL)
- 4.6 Configuring interfaces (COMMUNICATION)
- 4.6.1 COM1/COM2 -> MODE - operating mode of the serial interface
- 4.6.2 COM1/COM2 -> PRINTER - settings for protocol printout
- 4.6.3 COM1/COM2 -> PARAMET - communication parameter
- 4.6.4 COM1/COM2 -> RESET COM1/RESET COM2 - resetting serial interface to factory settings
- 4.6.5 OPTION - configuring options
- 4.6.6 DEF.PRN - configuring templates
- 4.7 Diagnosis and printing out of the menu settings (DIAGNOS)
- 5 Interface description
- 6 Event and error messages
- 7 Technical data and accessories
- 8 Appendix
- 9 Index