Ohaus CARAT & GOLD LIGHT PORTABLE JEWELRY BALANCES Manual multi - Manual (Page 17)

TAJ Carat / Gold Balances EN-9
4.2 Menu Navigation
Main level menus are identified by decimal points between each letter, for example
[
S.E.t.U.P].
Enter Menu: With the balance off, press and hold the On button. Continue
holding the On button until [
S.E.t.U.P] is displayed. Each main
menu is entered by pressing Yes. Advance to the next main menu
by pressing No.
Changing Settings: Within each main menu are sub-menus. Enter each sub-menu by
pressing Yes. Advance to the next sub-menu by pressing No. To
accept the displayed sub-menu setting, press Yes. To advance to
the next setting, press No.
Menu Exit: The last item in each sub-menu is [
EnD]. Press Yes to return to the
main menu. The last item in the main menu is [
E.n.D]. Press Yes
to return to the previous weighing mode.
4.2.1 Setup Menu
[
S.E.t.U.P.]
The Setup menu contains the following sub-menus:
Auto-Off [
.A-OFF.]:
Auto Off settings:
On, Off**.
Setting [ On] will automatically turn the balance off after no
activity is detected for 4 minutes.
Light [
LiGht]:
Backlight settings:
On, Off**, Auto.
Selecting [ Auto] will turn the backlight on when the balance
detects any activity. (Minimum 2 seconds)
Span Calibration [ SPAN]: Uses two weight values: Zero and a value at or near the full
capacity of the balance. Span calibration should be
performed if the balance is repositioned or when the room
temperature changes significantly.
Linearity Calibration [
Lin]: Uses three weight values: Zero, a mid-range value and full
capacity. Generally this calibration is not required unless
testing shows that the linearity error exceeds the linearity
tolerance in the specification table. Accuracy of weights is
important to maintain weighing integrity.
**Selecting [
Off] for these settings will reduce battery consumption.