Baud rate selection, Parity selection, Non dip switch – Ohaus AS 142 Impact Printer User Manual
Page 7: Odd 8-even 7-non 7-odd 7-even, 4800 dip switch
7
On\Off Mode (Cont.)
On\Off Mode (Cont.)
On\Off Mode (Cont.)
On\Off Mode (Cont.)
On\Off Mode (Cont.)
SEL has another function, to interrupt the printout. If SEL is pressed and then released
during a printout, the printer will stop after completing the current line. At this point, you
can load more paper. To complete the printout, press and release SEL button. The
printer will run again at the point the printout was interrupted.
Baud Rate Selection
Baud Rate Selection
Baud Rate Selection
Baud Rate Selection
Baud Rate Selection
The baud rate of serial interface can be selected as 150, 300, 600, 2400, 4800 or
9600bps. It can be set with internal DIP switches as required. To set the baud rate,
take off the removable cover and the upper case of the printer. You can see the DIP
switch in the upper right comer of the printed circuit board. Baud rate can be selected
as shown in the Baud Rate Selection table. The switch near the white mark is Sl. The
factory setting is Sl ON, S2 OFF, S3 OFF. The baud rate is 9600 bps.
Parity Selection
Parity Selection
Parity Selection
Parity Selection
Parity Selection
Parity Check can be set with S4 - S6 DIP
switches as shown in the Parity Selection
Table. These are set at NO Parity ex-
factory, S4 ON, S5 ON, S6 ON.
PARITY SELECTION TABLE
PARITY
ON
ON
ON
ON
ON
8-NON
DIP SWITCH
ON
ON
ON
ON
ON
ON
ON
ON
ON
ON
ON
ON
ON
ON
ON
ON
ON
ON
ON
ON
ON
ON
ON
ON
ON
8-ODD
8-EVEN
7-NON
7-ODD
7-EVEN
ON
ON
ON
ON
ON
ON
ON
ON
ON
ON
ON
ON
ON
ON
ON
ON
ON
ON
ON
ON
ON
ON
ON
ON
ON
ON
ON
ON
ON
ON
4800
DIP SWITCH
ON
ON
ON
ON
ON
150
300
600
1200
2400
9600
BAUD RATE SELECTION TABLE
B.P.S.
1 2 3 4 5 6
1 2 3 4 5 6
1 2 3 4 5 6
1 2 3 4 5 6
1 2 3 4 5 6
1 2 3 4 5 6
1 2 3 4 5 6
1 2 3 4 5 6
1 2 3 4 5 6
1 2 3 4 5 6
1 2 3 4 5 6
1 2 3 4 5 6
1 2 3 4 5 6