Ohaus MB300 Electronic Balances - Manual (Page 28)

INSTALLATION INSTALLATION INSTALLATION INSTALLATION INSTALLATION
Figure 1 shows the typical lock and
cable assembly for balances requiring
the Security Device Bushing to be in-
stalled in the balance.
WARNING: WARNING: WARNING: WARNING: WARNING: ALWAYS DISCONNECT
POWER BEFORE OPENING BAL-
ANCE.
2 3
E Series, Galaxy, GT400, E Series, Galaxy, GT400, E Series, Galaxy, GT400, E Series, Galaxy, GT400, E Series, Galaxy, GT400,
GT4000 and GT8000 Only GT4000 and GT8000 Only GT4000 and GT8000 Only GT4000 and GT8000 Only GT4000 and GT8000 Only
Port-O-Gram Balances Port-O-Gram Balances Port-O-Gram Balances Port-O-Gram Balances Port-O-Gram Balances
CT Series, C305, C505 and CT Series, C305, C505 and CT Series, C305, C505 and CT Series, C305, C505 and CT Series, C305, C505 and
S200 S200 S200 S200 S200
1. Remove Battery Cover and
Battery Pack.
2. Remove Hole Plug.
3. Install Security Device
Bushing in hole and install
Lock and Cable as in Fig-
ure 1.
4. Reassemble.
1. Remove screws which secure Bat-
tery Cover. Remove cover and bat-
tery pack.
2. Remove Hole Plug.
3. Install Security Device Bushing in
hole and install Lock and Cable as
in Figure 1.
4. Reassemble.
1
2 3
Security
Device
Bushing
Lock
Cable
Balance
Case
Figure 1 Figure 1 Figure 1 Figure 1 Figure 1
2
2
3
1
Rear of
balance
Pass Cable through hole.
3
1
2
1
1. Remove screws and washers which
secure cover to base and lift the
cover. Be careful not to pull any
wires, cables or connectors going
from the cover to the base.
2. Remove Hole Plug.
3. Install Security Device Bushing in
hole and install Lock and Cable as
in Figure 1.
4. Reassemble.
1
3
1. Remove the Draft Shield (if in-
stalled), Pan and Pan Support.
2. Remove the three screws
which secure cover to
base and lift cover off.
3. Remove Hole Plug.
4. Install Security Device Bush-
ing in hole and install Lock and
Cable as in Figure 1.
5. Reassemble.
PRECISION PRECISION PRECISION PRECISION PRECISION Standard Standard Standard Standard Standard Balances Balances Balances Balances Balances
MB200, PRECISION MB200, PRECISION MB200, PRECISION MB200, PRECISION MB200, PRECISION Plus Plus Plus Plus Plus and and and and and
All GT Series Except GT400, All GT Series Except GT400, All GT Series Except GT400, All GT Series Except GT400, All GT Series Except GT400,
GT4000 and GT8000 GT4000 and GT8000 GT4000 and GT8000 GT4000 and GT8000 GT4000 and GT8000
The Security Device Bushing is not re-
quired on these balances.
To install, simply pass the Cable through
the hole in the level indicator on the rear
of the balance.