Ohaus RANGER COMPACT COUNTING SCALES Manual en - Manual (Page 30)

Ranger RC
30
Settings in the menu
4.5 Terminal settings (TERMINAL)
4.5.1 DEVICE – Sleep mode, energy-saving mode and display backlighting
4.5.2 ACCESS – password for Supervisor menu access
4.5.3 RESET – resetting terminal settings to the factory settings
SLEEP This menu item only appears on devices in mains operation.
When SLEEP is activated, the scale switches off display and backlighting after the
time period set when not in use. The display and backlighting are switched on again
at the press of a key or if the weight changes.
Possible settings: OFF, 1 min, 3 min, 5 min
PWr OFF This menu item only appears on devices in battery operation.
When PWr OFF is activated, the device switches itself off automatically after
approx. 3 minutes when not in use.
b.LIGHt Switching the display backlighting on/off.
On scales with a battery, the background lighting switches itself off automatically if
there has been no activity on the scale for 5 seconds.
Note This menu item is accessible without a Supervisor password.
SUPErVI Password entry for Supervisor menu access
ENtER.C Request to enter password
Enter the password and confirm with Yes
rEtYPE.C Request to repeat the password entry
Enter the password again and confirm with Yes
Notes • The password can consist of up to 4 characters.
• The PRINT key must not be part of the password. It is required for confirming
the password.
• The ZERO key may only be used in combination with another key.
• If you enter an impermissible code or make a typing error in the repetition,
COdE.Err. appears in the display.
SUrE?
Confirmation inquiry
• Reset terminal settings to the factory settings with Yes
• Do not reset the terminal settings with No