Ohaus Scout II Electronic Balances - Manual (Page 13)

13
DATA BITS
1. With dATa displayed, press Zero On until -7- or -8- is displayed.
2. Press Mode Off to change the displayed setting to either -7- or -8-.
3. To accept the displayed setting, press Zero On. The display returns to
dAtA . To advance to Parity Bit, press Mode Off. If you don’t want to change
any other settings, press the Mode Off until End is displayed, then press
Zero On to save setting.
PARITY BIT
1. With PAr displayed, press Zero On until Odd, EvEn or nonE is displayed.
2. Press Mode Off to change the displayed setting to either Odd, EvEn or
nonE.
3. To accept the displayed setting, press Zero On. The display returns to
PAr . To advance to Stop Bits, press Mode Off. If you don’t want to change
any other settings, press the Mode Off until End is displayed, then press
Zero On to save setting.
STOP BITS
1. With StoP displayed, press Zero On until either -1- or -2- is displayed.
2. Press Mode Off to change the displayed setting to either -1- or -2-.
3. To accept the displayed setting, press Zero On. The display returns to
StoP . To advance to Auto Print, press Mode Off. If you don’t want to change
any other settings, press the Mode Off until End is displayed, then press
Zero On to save setting.
AUTO PRINT
1. With APrnt displayed, press Zero On until OnStb, OFF or Cont is displayed.
2. Press Mode Off to change the displayed setting to either , OnStb, OFF or
Cont .
3. To accept the displayed setting, press Zero On. The display returns to
APrnt . To advance to Stable Data, press Mode Off. If you don’t want to
change any other settings, press the Mode Off until End is displayed, then
press Zero On to save setting.
SETTING PRINT MENU FUNCTIONS (CONT.)